当前位置 博文首页 > thinkphp5使用bootstrapvalidator进行异步验证邮箱的示例

    thinkphp5使用bootstrapvalidator进行异步验证邮箱的示例

    作者:Big_fat_cat 时间:2021-09-21 19:08

    本文介绍了thinkphp5使用bootstrapvalidator进行异步验证邮箱的示例,分享给大家,具体如下:

    js验证

    /**
     * Created by HONGXIN on 2017-10-23.
     */
    $(function () {
      $('form').bootstrapValidator({
    
        message: 'This value is not valid',
        feedbackIcons: {
          valid: 'glyphicon glyphicon-ok',
          invalid: 'glyphicon glyphicon-remove',
          validating: 'glyphicon glyphicon-refresh'
        },
    
        live: 'disabled',//验证失败后,提交按钮仍然是可选状态
    
        fields: {
          email: {
            message: '用户名验证失败',//默认
            verbose: false,
            validators: {
              notEmpty: {
                message: '邮箱不能为空'
              },
              emailAddress: {
                message: '邮箱地址格式有误'
              },
              remote: {
                url: '/ajax_email',
                message:"此邮箱已经注册",
                type: "post",
                dataType: 'json',
                data: {
                  //默认传递的就是输入框的值
                },
                delay: 500,//延迟效果
              },
            }
          },
          password: {
            validators: {
              notEmpty: {
                message: '邮箱地址不能为空'
              },
              stringLength: {
                min: 6,
                max: 18,
                message: '用户名长度必须在6到18位之间'
              },
            },
          },
          password2: {
            validators: {
              notEmpty: {
                message: '确认密码不能为空'
              },
              identical: {
                field: 'password',
                message: '两次密码必须一致'
              }
            }
          },
          username:{
            validators: {
              notEmpty: {
                message: '用户名不能为空'
              },
              stringLength: {
                min: 2,
                max: 8,
                message: '用户名长度必须在2到8位之间'
              }
            }
          }
    
        }
      });
    });
    
    

    TP5处理

      public function ajax_email(){
        //该message可以为空,它替换JS验证的message属性
        echo json_encode(['valid'=>false,'message'=>'验证码不正确']);
    
      }
    
    

    js验证几个注意点

    1. verbose: false,代表js验证合法后再异步后台验证,这样减少服务器压力
    2. data: {} ,默认传递的就是输入框的值,所以一般不用写该属性,或者为空即可

    后台注意点

    1. 注意不是return而是echo
    2. 返回json格式 {'valid':true[,'message':'验证成功']}

    参考链接: 使用bootstrapvalidator的remote验证经验

    参考链接:BootstrapValidator超详细教程

    jsjbwy